According to the online A2 manual http://www.oneilcastro.com/A2Bentley/index.html It is not difficult do disassemble the bit if you knowhow. Some disassembly of the distributor is required to replace the Hall sender. It will require a snap-ring plier and. It is possible to disassemble the base plate, the distributor shaft, and the centrifugal advance mechanism, but these […]

DIY, Mk1 GTI Project | No Comments »

Momo steering wheel & Wolfsburg window winders [ 403 forbidden | | 403 forbidden | ]

Mk1 GTI Project | No Comments »

Have replaced the worn-down rotor arm on the distributor this morning. The one on the left is a new one and the old one is on the RHS. Check out the tip on the old one, it is worn out badly and need to dump it in the trash rite away. [ forbidden | | […]

Mk1 GTI Project | 1 Comment »