Was helping out a friend to check out a car @ John’s house and luckily I found the following items that could be usable on my “I”
1. Air intake rubber boots, one that connected to the fuel metering unit and the other connected to the throttle body)
2. Hall sender cable connector
As you can see from the photo, the one originally on the “I” is badly worn out and causing air leaks and they had to go for sure. After all those work, step on the gas paddle, now the throttle is more responsive then before. This is what I called a small change does make a big difference. What about the cost??? ha HK$150 … even cheaper than what I can get from ebay … if there were any !!
Worn out intake rubber boot
Hall sender cable replaced.
intake rubber boots installed.